Carefully dop the ball back
into teh valve and gently start the retainer with spring in the valve.
Use the head of a screwdriver or small hammer to tap the retainer back
in unitl it is just flush with the top of the valve. Slow and easy here.
Too far and you're back to disassembly and reassembly again.
Once flush carefully back the
screw out and you should end up as shown below. The blow-suck test should
confirm that air will pass in one direction and not the other.
There is a second valve identical
to this one in the number two bowl, but often that one does not get nearly
as crudded up. If it has the same procedure applies. That's it, Done!
Houndog750 |
