.
Carburetor Information
U.S. CB750 Models 1969-1978
...|...Home...|...Garage...|...Carb Info Index...|...
...|...Previous Page...|...Next Page...|...
Repairing 77-78 carb accelerator pump valves - Pg 3
Once you have the hole bored carefully run the small screw into the retainer as shown. It only needs to be snugged up, not super tight. Go too far and you could either split the retainer or strip out the hole and the game gets a lot harder or ends abruptly then.
Gently wiggle the screw ever so slightly and if it's in the retainer well pulling firmly should pull the retainer out without too much difficulty.
The key here is to go slow and deliberate. There is a small spring just under the retainer that fits the end of the retainer. Yank that puppy out too fast and that spring could easily go flying. There is also a small steel ball at the bottom of the vavle that rests under that spring. If either spring or ball goes flying it's game over unless you can find the little boogers.
...|...Previous Page...|...Next Page...|...
.
Original Content Copyright 2009, all rights reserved
Exclusive permissions granted solely to hondachopper.com